Bosch fridge repair in Nairobi.
Built-in and freestanding fridge freezers with no-frost cooling. We repair them at your home, with the price agreed before any work starts.
Common Bosch fridge jobs.
- Fan and defrost repairs
- Electronic control faults
- Door seal replacement
What is the Bosch fridge doing?
Bosch fridge repair by area.
Our technicians cover all of Nairobi and the towns around it. Pick your area for the full Bosch page there.
The models we see and how they are built.
Bosch fridge freezers are often built into kitchen units, and freestanding models have electronic control panels. They use no-frost cooling, with a fan that moves cold air around the cabinet and an automatic defrost that clears the evaporator. Built-in fridges need correct airflow and door alignment to work properly.
Because Bosch units have electronic controls, a fault can look like a dead panel, a control that does not respond, or a fridge that cools in one mode and not another. We check the power, the control board and the sensors before we condemn a part.
Bosch fridge freezers are often built into kitchens or sold as freestanding models with electronic controls. They use no-frost cooling, so a fault can show up as ice in the freezer, a warm fridge side, or a control panel that does not respond.
When a Bosch fridge is not right, we start with the fan, the defrost heater and the electronic controls, since those are the usual causes. Door seals on built-in models are also worth checking, because the door alignment can change over time.
What Bosch owners notice first.
- Fan and defrost faults
- Electronic control faults
- Door seal replacement
- Built-in fridge not level
- Noise from the fan
What goes wrong, and why.
Fan and defrost faults
If the freezer frosts up or the fridge side warms, the fan or the defrost heater is the first thing to check. A fan blocked with ice or a worn motor reduces the airflow. A defrost heater that does not switch on lets the ice build up until the cooling stops.
Electronic control faults
A control panel that is blank, unresponsive or shows the wrong temperature points to the control board, a ribbon cable or a sensor. We test the connections and the board before replacing anything, because a loose connector is often the cause.
Door seal replacement
Built-in fridges sit in tight cabinets, so the door can rub or sag over time. A worn seal or a door out of line lets in warm, damp air. We adjust the door and fit a matching seal so it closes evenly all the way round.
Built-in fridge not level
A fridge built into a unit has to sit level or the door will not close flush. When the door drops, the seal stops meeting the cabinet. Levelling the feet is quick and often fixes both the seal and the frost problem.
Noise from the fan
A rattling or whining sound from the back usually means the fan is touching ice, has worn bearings, or is loose on its mount. We listen to the fridge and check the fan before replacing it.
Care that prevents a repair.
Keep the fridge clear of dust at the back and underneath. Built-in units are hard to reach, so plan a yearly clean with the technician during a service visit.
Do not block the vents inside the cabinet. The cold air has to reach every shelf, and packed food stops the air moving. Let hot food cool before it goes in.
Most Bosch faults are a fan, a defrost part, a seal or a connector, and those are repaired in one visit. A built-in unit that needs a new cabinet or a whole control module may be better replaced, and we will tell you the difference between the two options.
How a Bosch visit works.
Tell us what is wrong
Call or WhatsApp with what the fridge is doing and a photo of the model sticker inside.
We come to you
A technician visits your home or business and finds the fault.
You approve the price
You get the full price before any work starts. Nothing is done without your OK.
Cold again
We repair it, test the temperature and show you what was fixed.
Questions people ask
Do you repair Bosch fridges at home in Nairobi?
Yes. A technician comes to your home or business and repairs the Bosch fridge where it stands, in most cases in one visit.
Are you the official Bosch service centre?
No. We are independent fridge technicians. If your Bosch fridge is still under the manufacturer's warranty, contact the shop or Bosch first.
Do you have parts for Bosch fridges?
We source the right part for your model. Send a photo of the rating plate inside the fridge so we can check before we come.
Good to know about your fridge.
How a fridge actually keeps things cold
A fridge does not make cold. It moves heat. Inside the sealed pipework there is a refrigerant gas. The compressor squeezes the gas, which makes it hot, and the hot gas flows through the coil at the back or underneath, called the condenser, where it gives its heat to the room. The gas turns to a liquid, passes through a very thin tube that drops its pressure, and arrives in the cold coil inside the fridge, the evaporator, where it turns back to a gas and soaks up heat from the food. Then it returns to the compressor and the cycle repeats.
That is why the back of a fridge feels warm and why a fridge squeezed into a cabinet struggles. If the heat cannot leave, the cycle slows and the compressor runs for longer. It is also why gas does not get used up: it travels round in a closed loop. When a fridge is low on gas there is a leak, and the leak has to be found and sealed first.
In a no-frost fridge a fan blows air over the evaporator and into the compartments, and a small heater melts the frost off the coil a few times a day. Most cooling faults come from these supporting parts, the fan, the heater, the sensor and the board, long before the compressor itself fails.
Reading the rating plate inside your fridge
Almost every fridge has a sticker or metal plate inside, usually on a side wall or at the back of the fridge compartment. It tells a technician almost everything: the brand, the model number, the voltage and frequency, the type of gas the fridge uses and how much of it, and often the manufacturing date.
Take a clear photo of that plate before you call. With the model number we can check which thermostat, seal, fan or board fits, which saves time on the visit. The gas type matters too. Modern fridges often use R600a, a flammable gas used in small amounts, while older ones commonly use R134a. The two are not interchangeable, and a fridge must always be charged with the gas printed on its own plate.
If you cannot find the plate, look for a sticker behind the vegetable drawers, on the inside of the door frame or on the back of the cabinet. Send us whatever you can find and the brand, and we will help you identify the model.
Protecting a fridge from power cuts and surges
Power cuts and surges are hard on fridges. When the supply returns it can arrive with a spike that damages the control board or the parts that start the compressor. Inverter fridges are the most sensitive, because a board sits between the plug and the compressor.
A good voltage guard, also called a fridge guard, delays the power coming back for a few minutes and cuts it if the voltage is too high or too low. It costs far less than a board repair. Choose one rated for the fridge, plug the fridge into it directly and avoid sharing the socket with a heater or an iron.
After any outage, wait a few minutes before switching the fridge on if you do not have a guard. Keep the door closed during the cut. A full fridge holds its cold for several hours if it is not opened, and a full freezer holds it for longer. Do not keep switching the fridge off and on at the wall; it puts strain on the compressor.
Fridges and freezers we work on.
Bosch fridge not right?
Call or WhatsApp with what the fridge is doing and a photo of the model sticker. We tell you when a technician can come.