LG fridge repair in Kiambu.
A LG fridge is one of the more common fridges in Kiambu. When it stops cooling, our technicians come to your home in Kiambu and repair it on site. We cover Kiambu and nearby Kiambu Town, Ndumberi, Kirigiti and Thindigua.
About the fridges we repair.
Linear and inverter compressor models, side-by-side and door-in-door fridges.
In Kiambu we see LG fridges in homes, offices and shops. The usual jobs are below. Each one is a link to the full page on what causes it and how we fix it.
What we see most.
- Cooling getting weaker over time
- Fan and defrost faults causing ice
- Board faults after surges
- Not cooling
- Freezer not freezing
- Gas refilling
Start from what the fridge is doing.
The pages below explain the usual causes and how we fix each one. No codes, no jargon.
Where else we come.
We cover Nairobi and the towns around it. If you are near Kiambu, we usually reach you the same day.
We repair every fridge brand sold in Kenya.
If your fridge in Kiambu is a different brand, pick it below. The visit, the price-first process and the same-day cover are the same.
LG fridges and Kiambu homes.
LG fridges in Kenya include inverter models with a linear compressor, side-by-side fridges, door-in-door models and double door fridges. A linear compressor moves a piston in a straight line rather than spinning a motor, which is quiet and efficient, but it relies on the control board to drive it smoothly.
Kiambu town has homes, shops and small businesses. Fridges are used hard, and in damp kitchens moisture can corrode plugs, boards and connections.
What we fix on LG fridges.
Noise from the compressor
A linear compressor makes a soft hum. A louder buzz, a rattle or a click that repeats every few minutes can mean the compressor is struggling to start, the mounts have loosened or a pipe is touching the cabinet. We listen to the fridge in operation before diagnosing.
Door alignment and seal wear
Door-in-door and heavy double doors can drop slightly over time. When the door sags, the seal stops meeting the cabinet along one side. Adjusting the hinge or replacing the seal is a quick job that prevents frost and wasted power.
Cooling gets weaker over months
A fridge that cools less each month often has a dirty condenser, a fan that is slowing down, or a leaking gas circuit. We check the airflow and the fan first. Gas is only refilled after a leak has been found and sealed.
What we see in Kiambu kitchens.
Corroded connections
Moisture damages plugs and board connectors. We clean the contacts or replace the damaged parts, and advise on keeping the fridge dry.
Ice build-up
The defrost heater, the sensor or the timer has stopped working. We test each and replace the failed one.
Care that prevents a repair.
Clean the condenser twice a year, and keep the area around the compressor free of dust and grease. Keep the door seal clean with warm water, because grease from food can stop it sealing properly.
Keep the fridge dry and clean, check the seal with a sheet of paper, and leave a gap behind it for air.
Most LG fridge faults are a fan, a sensor, a seal or a board, and those repair well. A fridge with a failed linear compressor and a cabinet that is otherwise in good shape can still be repaired if the part is available. We tell you the price and the options before any work starts.
How a Kiambu visit works.
Tell us what is wrong
Call or WhatsApp with what the fridge is doing and a photo of the model sticker inside.
We come to you
A technician visits your home or business and finds the fault.
You approve the price
You get the full price before any work starts. Nothing is done without your OK.
Cold again
We repair it, test the temperature and show you what was fixed.
Questions people ask
Do you repair LG fridges in Kiambu?
Yes. A technician from our team comes to your home in Kiambu and repairs the LG fridge where it stands. Most repairs are finished in one visit.
How soon can you reach Kiambu?
Often the same day for Kiambu and nearby Kiambu Town. Call or WhatsApp 0703 543 656 early in the day and we tell you the earliest time a technician can reach you.
Are you the official LG service centre?
No. We are independent fridge technicians, not affiliated with LG. For a LG fridge still under the manufacturer warranty, contact the shop or LG first.
Do you have LG fridge spare parts?
We source the right part for your model. Send a photo of the rating plate inside the fridge (brand, model number, gas type) before we come so we can check.
Good to know about your fridge.
How a fridge actually keeps things cold
A fridge does not make cold. It moves heat. Inside the sealed pipework there is a refrigerant gas. The compressor squeezes the gas, which makes it hot, and the hot gas flows through the coil at the back or underneath, called the condenser, where it gives its heat to the room. The gas turns to a liquid, passes through a very thin tube that drops its pressure, and arrives in the cold coil inside the fridge, the evaporator, where it turns back to a gas and soaks up heat from the food. Then it returns to the compressor and the cycle repeats.
That is why the back of a fridge feels warm and why a fridge squeezed into a cabinet struggles. If the heat cannot leave, the cycle slows and the compressor runs for longer. It is also why gas does not get used up: it travels round in a closed loop. When a fridge is low on gas there is a leak, and the leak has to be found and sealed first.
In a no-frost fridge a fan blows air over the evaporator and into the compartments, and a small heater melts the frost off the coil a few times a day. Most cooling faults come from these supporting parts, the fan, the heater, the sensor and the board, long before the compressor itself fails.
Reading the rating plate inside your fridge
Almost every fridge has a sticker or metal plate inside, usually on a side wall or at the back of the fridge compartment. It tells a technician almost everything: the brand, the model number, the voltage and frequency, the type of gas the fridge uses and how much of it, and often the manufacturing date.
Take a clear photo of that plate before you call. With the model number we can check which thermostat, seal, fan or board fits, which saves time on the visit. The gas type matters too. Modern fridges often use R600a, a flammable gas used in small amounts, while older ones commonly use R134a. The two are not interchangeable, and a fridge must always be charged with the gas printed on its own plate.
If you cannot find the plate, look for a sticker behind the vegetable drawers, on the inside of the door frame or on the back of the cabinet. Send us whatever you can find and the brand, and we will help you identify the model.
Protecting a fridge from power cuts and surges
Power cuts and surges are hard on fridges. When the supply returns it can arrive with a spike that damages the control board or the parts that start the compressor. Inverter fridges are the most sensitive, because a board sits between the plug and the compressor.
A good voltage guard, also called a fridge guard, delays the power coming back for a few minutes and cuts it if the voltage is too high or too low. It costs far less than a board repair. Choose one rated for the fridge, plug the fridge into it directly and avoid sharing the socket with a heater or an iron.
After any outage, wait a few minutes before switching the fridge on if you do not have a guard. Keep the door closed during the cut. A full fridge holds its cold for several hours if it is not opened, and a full freezer holds it for longer. Do not keep switching the fridge off and on at the wall; it puts strain on the compressor.
Fridges and freezers we work on.
LG fridge in Kiambu not right?
Call or WhatsApp with what the fridge is doing and a photo of the model sticker. We tell you when a technician can come.