Mika fridge repair in Runda.
A Mika fridge is one of the more common fridges in Runda. When it stops cooling, our technicians come to your home in Runda, Nairobi and repair it on site. We cover Runda and nearby Gigiri, Muthaiga North, Rosslyn and Village Market.
About the fridges we repair.
Single and double door fridges and freezers, budget friendly.
In Runda we see Mika fridges in homes, offices and shops. The usual jobs are below. Each one is a link to the full page on what causes it and how we fix it.
What we see most.
- Thermostat faults
- Door seals
- Gas leaks
- Not cooling
- Freezer not freezing
- Gas refilling
Start from what the fridge is doing.
The pages below explain the usual causes and how we fix each one. No codes, no jargon.
Where else we come.
We cover Nairobi and the towns around it. If you are near Runda, we usually reach you the same day.
We repair every fridge brand sold in Kenya.
If your fridge in Runda is a different brand, pick it below. The visit, the price-first process and the same-day cover are the same.
Mika fridges and Runda homes.
Mika fridges are budget-friendly single and double door fridges and freezers. They are simple machines with a compressor, a thermostat and a gas circuit, and they are a common sight in bedsitters, offices and small kitchens across Nairobi.
Runda is quiet, residential and spacious, with large family homes and well-equipped kitchens. Built-in and integrated fridges are common, and so are wine coolers and second fridges.
What we fix on Mika fridges.
Door seals
A worn seal lets warm air in and the fridge runs longer than it should. Close the door on a sheet of paper to check. Replacing the seal and adjusting the door is a quick job that cuts power use and stops frost.
Gas leaks
A fridge that runs without getting cold is often low on gas through a leak. The leak is usually at a joint or in a pipe that has rubbed. We find and seal the leak, vacuum the system and charge the correct gas. We never refill without a repair.
Start relay and compressor clicks
A fridge that clicks and does not start usually has a failed start relay. The relay is inexpensive, and we check it matches the compressor before fitting. If the compressor has failed electrically, we explain the cost before doing anything.
What we see in Runda kitchens.
Built-in fridge with blocked vents
Integrated fridges need open vents at the top and bottom of the cabinet. Blocked vents trap heat and weaken the cooling.
Wine cooler temperature drift
The compressor type and the thermoelectric type have different faults. Fans, sensors and seals are the first checks.
Care that prevents a repair.
Clean the condenser at the back every few months. On budget fridges, dust reduces cooling more than most owners expect. A quick brush with the fridge unplugged makes a real difference.
Have your built-in fridge cleaned and checked yearly, including the vents. Keep the wine cooler out of direct sun and away from heat sources.
Mika repairs are often very affordable, so the sensible choice is usually to repair. If the cabinet is damaged, the compressor has failed or the fridge is old and uses a lot of power, replacing it may make more sense. We give you the numbers first.
How a Runda visit works.
Tell us what is wrong
Call or WhatsApp with what the fridge is doing and a photo of the model sticker inside.
We come to you
A technician visits your home or business and finds the fault.
You approve the price
You get the full price before any work starts. Nothing is done without your OK.
Cold again
We repair it, test the temperature and show you what was fixed.
Questions people ask
Do you repair Mika fridges in Runda?
Yes. A technician from our team comes to your home in Runda, Nairobi and repairs the Mika fridge where it stands. Most repairs are finished in one visit.
How soon can you reach Runda?
Often the same day for Runda and nearby Gigiri. Call or WhatsApp 0703 543 656 early in the day and we tell you the earliest time a technician can reach you.
Are you the official Mika service centre?
No. We are independent fridge technicians, not affiliated with Mika. For a Mika fridge still under the manufacturer warranty, contact the shop or Mika first.
Do you have Mika fridge spare parts?
We source the right part for your model. Send a photo of the rating plate inside the fridge (brand, model number, gas type) before we come so we can check.
Good to know about your fridge.
How a fridge actually keeps things cold
A fridge does not make cold. It moves heat. Inside the sealed pipework there is a refrigerant gas. The compressor squeezes the gas, which makes it hot, and the hot gas flows through the coil at the back or underneath, called the condenser, where it gives its heat to the room. The gas turns to a liquid, passes through a very thin tube that drops its pressure, and arrives in the cold coil inside the fridge, the evaporator, where it turns back to a gas and soaks up heat from the food. Then it returns to the compressor and the cycle repeats.
That is why the back of a fridge feels warm and why a fridge squeezed into a cabinet struggles. If the heat cannot leave, the cycle slows and the compressor runs for longer. It is also why gas does not get used up: it travels round in a closed loop. When a fridge is low on gas there is a leak, and the leak has to be found and sealed first.
In a no-frost fridge a fan blows air over the evaporator and into the compartments, and a small heater melts the frost off the coil a few times a day. Most cooling faults come from these supporting parts, the fan, the heater, the sensor and the board, long before the compressor itself fails.
Reading the rating plate inside your fridge
Almost every fridge has a sticker or metal plate inside, usually on a side wall or at the back of the fridge compartment. It tells a technician almost everything: the brand, the model number, the voltage and frequency, the type of gas the fridge uses and how much of it, and often the manufacturing date.
Take a clear photo of that plate before you call. With the model number we can check which thermostat, seal, fan or board fits, which saves time on the visit. The gas type matters too. Modern fridges often use R600a, a flammable gas used in small amounts, while older ones commonly use R134a. The two are not interchangeable, and a fridge must always be charged with the gas printed on its own plate.
If you cannot find the plate, look for a sticker behind the vegetable drawers, on the inside of the door frame or on the back of the cabinet. Send us whatever you can find and the brand, and we will help you identify the model.
Protecting a fridge from power cuts and surges
Power cuts and surges are hard on fridges. When the supply returns it can arrive with a spike that damages the control board or the parts that start the compressor. Inverter fridges are the most sensitive, because a board sits between the plug and the compressor.
A good voltage guard, also called a fridge guard, delays the power coming back for a few minutes and cuts it if the voltage is too high or too low. It costs far less than a board repair. Choose one rated for the fridge, plug the fridge into it directly and avoid sharing the socket with a heater or an iron.
After any outage, wait a few minutes before switching the fridge on if you do not have a guard. Keep the door closed during the cut. A full fridge holds its cold for several hours if it is not opened, and a full freezer holds it for longer. Do not keep switching the fridge off and on at the wall; it puts strain on the compressor.
Fridges and freezers we work on.
Mika fridge in Runda not right?
Call or WhatsApp with what the fridge is doing and a photo of the model sticker. We tell you when a technician can come.