Mika fridge repair in Kikuyu.
A Mika fridge is one of the more common fridges in Kikuyu. When it stops cooling, our technicians come to your home in Kikuyu, Kiambu and repair it on site. We cover Kikuyu and nearby Kinoo, Sigona, Thogoto and Zambezi.
About the fridges we repair.
Single and double door fridges and freezers, budget friendly.
In Kikuyu we see Mika fridges in homes, offices and shops. The usual jobs are below. Each one is a link to the full page on what causes it and how we fix it.
What we see most.
- Thermostat faults
- Door seals
- Gas leaks
- Not cooling
- Freezer not freezing
- Gas refilling
Start from what the fridge is doing.
The pages below explain the usual causes and how we fix each one. No codes, no jargon.
Where else we come.
We cover Nairobi and the towns around it. If you are near Kikuyu, we usually reach you the same day.
We repair every fridge brand sold in Kenya.
If your fridge in Kikuyu is a different brand, pick it below. The visit, the price-first process and the same-day cover are the same.
Mika fridges and Kikuyu homes.
Mika fridges are budget-friendly single and double door fridges and freezers. They are simple machines with a compressor, a thermostat and a gas circuit, and they are a common sight in bedsitters, offices and small kitchens across Nairobi.
Kikuyu has family homes, small farms and many households that keep a chest freezer or a second fridge for bulk food and produce. These units run for long hours, so seals and thermostats wear.
What we fix on Mika fridges.
Thermostat faults
A thermostat that stops responding means the compressor either runs all the time or does not run at all. We test the thermostat and replace it if it does not switch correctly. It is a small part and the fridge should cool to the setting after the repair.
Door seals
A worn seal lets warm air in and the fridge runs longer than it should. Close the door on a sheet of paper to check. Replacing the seal and adjusting the door is a quick job that cuts power use and stops frost.
Gas leaks
A fridge that runs without getting cold is often low on gas through a leak. The leak is usually at a joint or in a pipe that has rubbed. We find and seal the leak, vacuum the system and charge the correct gas. We never refill without a repair.
What we see in Kikuyu kitchens.
Thermostat that no longer responds
A worn thermostat keeps the unit too warm or too cold, and the dial stops making a difference. We test it and fit the correct replacement.
Dusty condenser in a store room
Store rooms collect dust that coats the condenser and shortens the compressor's life. A clean is simple and effective.
Care that prevents a repair.
Clean the condenser at the back every few months. On budget fridges, dust reduces cooling more than most owners expect. A quick brush with the fridge unplugged makes a real difference.
Clean the coil twice a year, check the seal with paper, and do not overload the freezer. Overfilling blocks the cold air from moving.
Mika repairs are often very affordable, so the sensible choice is usually to repair. If the cabinet is damaged, the compressor has failed or the fridge is old and uses a lot of power, replacing it may make more sense. We give you the numbers first.
How a Kikuyu visit works.
Tell us what is wrong
Call or WhatsApp with what the fridge is doing and a photo of the model sticker inside.
We come to you
A technician visits your home or business and finds the fault.
You approve the price
You get the full price before any work starts. Nothing is done without your OK.
Cold again
We repair it, test the temperature and show you what was fixed.
Questions people ask
Do you repair Mika fridges in Kikuyu?
Yes. A technician from our team comes to your home in Kikuyu, Kiambu and repairs the Mika fridge where it stands. Most repairs are finished in one visit.
How soon can you reach Kikuyu?
Often the same day for Kikuyu and nearby Kinoo. Call or WhatsApp 0703 543 656 early in the day and we tell you the earliest time a technician can reach you.
Are you the official Mika service centre?
No. We are independent fridge technicians, not affiliated with Mika. For a Mika fridge still under the manufacturer warranty, contact the shop or Mika first.
Do you have Mika fridge spare parts?
We source the right part for your model. Send a photo of the rating plate inside the fridge (brand, model number, gas type) before we come so we can check.
Good to know about your fridge.
Moving a fridge without damaging it
Whenever possible, keep a fridge upright. The compressor oil sits in a defined place, and laying the fridge down can let it run into the pipes. If a fridge has to travel on its side, let it stand upright for several hours before you switch it on again.
Empty it and defrost the freezer the day before, so no water leaks on the way out. Secure the doors with tape and protect the corners. Plan the route, because large fridges are heavy and awkward on stairs, so tell your movers the size and the floor.
Level the fridge in its new position, leave a gap behind and above it and wait a short time before switching it on. We also help with installation and relocation, including bringing in a new fridge and removing the old one.
Saving power with the fridge you already have
A fridge runs all day and every day, so small improvements add up. Set the fridge between about three and five degrees and the freezer at minus eighteen. Colder settings use more power without protecting the food any better.
Keep the condenser clean, leave air space around the fridge and keep it away from the cooker and direct sun. Check the door seal and do not leave the door open while you decide what to eat.
A full fridge holds its cold better than an empty one, so a few bottles of water on the shelves help in a fridge that is mostly empty. Do not overpack it, though, because the air must still move. If a fridge is very old and the compressor is struggling, a replacement may repay itself in power, and we will tell you honestly if that applies.
Inverter fridges explained
A traditional compressor switches fully on and fully off. An inverter compressor changes its speed to suit the cooling needed. It runs slowly most of the time, which is quieter and uses less power, and it speeds up when the fridge needs to cool down.
To do that it needs a control board, called the inverter board, that converts the power and drives the compressor. The board is the weak point, because it dislikes surges and heat. When a board fails, the compressor does not start, even though the compressor itself may be fine.
That is why we test the board, the wiring and the compressor separately. A board can sometimes be repaired and sometimes needs replacing with a matching part. A voltage guard and a clean condenser are the best protection for an inverter fridge.
What happens on a visit
You call or WhatsApp us with what the fridge is doing and a photo of the model sticker. We tell you when a technician can come and how the visit fee works. The technician arrives, listens to the fridge, measures the temperature in both sections and checks the obvious causes in order.
When the fault is found, you are told what it is, shown the worn part where possible and given the full price for parts and labour before anything is changed. Nothing is done without your agreement. If a part has to be ordered, we tell you how long it will take.
After the repair, the fridge is left running and checked to confirm it is pulling down to temperature. Before we leave, we explain what failed and how to avoid it next time. If the fridge is not worth repairing, we say so, and we can collect an old fridge for responsible recycling.
Fridges and freezers we work on.
Mika fridge in Kikuyu not right?
Call or WhatsApp with what the fridge is doing and a photo of the model sticker. We tell you when a technician can come.