
Mika fridge repair in Thika.
We repair Mika fridges and freezers across Thika, Kiambu and the estates around it. You get a visit, a diagnosis and a clear price before any work starts. We cover Thika and nearby Makongeni, Landless, Ngoingwa and Section 9.
About the fridges we repair.
Single and double door fridges and freezers, budget friendly.
In Thika we see Mika fridges in homes, offices and shops. The usual jobs are below. Each one is a link to the full page on what causes it and how we fix it.
What we see most.
- Thermostat faults
- Door seals
- Gas leaks
- Not cooling
- Freezer not freezing
- Gas refilling
Start from what the fridge is doing.
The pages below explain the usual causes and how we fix each one. No codes, no jargon.
Where else we come.
We cover Nairobi and the towns around it. If you are near Thika, we usually reach you the same day.
We repair every fridge brand sold in Kenya.
If your fridge in Thika is a different brand, pick it below. The visit, the price-first process and the same-day cover are the same.
Mika fridges and Thika homes.
Mika fridges are budget-friendly single and double door fridges and freezers. They are simple machines with a compressor, a thermostat and a gas circuit, and they are a common sight in bedsitters, offices and small kitchens across Nairobi.
Thika is a busy town of homes, restaurants, shops and butcheries. Chest freezers and display fridges are everywhere, and when one fails the stock is at risk the same hour, so we treat these calls as urgent.
What we fix on Mika fridges.
Freezer not freezing
A single door fridge with an ice box, or a small freezer, can lose its cold through a seal or a thermostat fault. We check those first and then look at the gas if the cold does not come back.
Thermostat faults
A thermostat that stops responding means the compressor either runs all the time or does not run at all. We test the thermostat and replace it if it does not switch correctly. It is a small part and the fridge should cool to the setting after the repair.
Door seals
A worn seal lets warm air in and the fridge runs longer than it should. Close the door on a sheet of paper to check. Replacing the seal and adjusting the door is a quick job that cuts power use and stops frost.
What we see in Thika kitchens.
Butchery and shop freezers losing cold
Heavy daily use wears lid seals and thermostats. A freezer that no longer reaches freezing needs the seal and thermostat checked first, then the gas circuit.
Display fridge fans and condensers
In a busy shop, fans clog with dust and the condenser coats with grease. The unit cannot reject heat, the temperature drifts up and the compressor works harder. A clean and a fan check usually restore it.
Care that prevents a repair.
Clean the condenser at the back every few months. On budget fridges, dust reduces cooling more than most owners expect. A quick brush with the fridge unplugged makes a real difference.
In a shop, clean the condenser monthly, check seals weekly with a sheet of paper, and do not overpack the cooler. Cold air needs space to move.
Mika repairs are often very affordable, so the sensible choice is usually to repair. If the cabinet is damaged, the compressor has failed or the fridge is old and uses a lot of power, replacing it may make more sense. We give you the numbers first.
How a Thika visit works.
Tell us what is wrong
Call or WhatsApp with what the fridge is doing and a photo of the model sticker inside.
We come to you
A technician visits your home or business and finds the fault.
You approve the price
You get the full price before any work starts. Nothing is done without your OK.
Cold again
We repair it, test the temperature and show you what was fixed.
Questions people ask
Do you repair Mika fridges in Thika?
Yes. A technician from our team comes to your home in Thika, Kiambu and repairs the Mika fridge where it stands. Most repairs are finished in one visit.
How soon can you reach Thika?
Often the same day for Thika and nearby Makongeni. Call or WhatsApp 0703 543 656 early in the day and we tell you the earliest time a technician can reach you.
Are you the official Mika service centre?
No. We are independent fridge technicians, not affiliated with Mika. For a Mika fridge still under the manufacturer warranty, contact the shop or Mika first.
Do you have Mika fridge spare parts?
We source the right part for your model. Send a photo of the rating plate inside the fridge (brand, model number, gas type) before we come so we can check.
Good to know about your fridge.
How to defrost a freezer safely
A freezer with thick ice works harder and holds less. If your freezer is not no-frost, defrost it when the ice is a few millimetres thick. Switch it off at the wall, empty the contents into a cool box, and open the door. Put towels underneath to catch the water.
Never use a knife, a screwdriver or any sharp tool to chip the ice. The cooling pipes run very close to the surface, and a puncture lets out the gas and ruins the freezer. A bowl of warm water placed inside speeds things up, and a hairdryer on a low setting held at a distance can help, if you keep it away from water.
Wipe the inside dry before switching on again, and give the fridge a few hours to cool before refilling it. If ice builds up again within weeks, the door seal or the defrost system needs a technician.
How to load a fridge so it cools better
Cold air has to move. Pack the shelves loosely enough that air can circulate, and never block the vents at the back or on the ceiling of the compartment. Keep the bulky items on the shelves and leave the door bins for things that tolerate warmth.
Raw meat and fish belong on the lowest shelf in sealed containers, so they cannot drip onto other food. Dairy and cooked food go in the middle. Fruit and vegetables belong in the drawers, where the humidity is higher.
Let hot food cool to room temperature before putting it in. Hot pots warm the fridge, force the compressor to work and bring in moisture that turns into frost. Cover liquids, because uncovered liquids add moisture to the air.
Cleaning the condenser coil
The condenser coil releases the heat the fridge removes from the food. On older fridges it is a grille on the back; on newer ones it may be a coil under the fridge behind a kick plate. Dust and kitchen grease form a blanket on it, which traps the heat.
Unplug the fridge before you start. Use a soft brush or the brush attachment of a vacuum cleaner to lift the dust, then a damp cloth for grease. Clean the area around the compressor too, and remove dust from the fan if there is one. Do it every few months, or more often in a dusty kitchen.
A clean coil can make a noticeable difference in how long the compressor runs and how much power the fridge uses. It is one of the cheapest and most effective bits of maintenance you can do yourself.
How to tell if a door seal needs replacing
The door seal, or gasket, keeps warm air out. Over time it hardens, cracks or loses its magnetic grip. A bad seal causes frost, water inside, longer running and a higher bill.
Try the paper test: close the door on a sheet of paper and pull it out. If it slides out with no resistance, the seal is not gripping there. Test several points around the door. Look for splits, hardened sections and mould along the folds.
Wiping the seal with warm soapy water sometimes restores the grip, because grease and sugar stop it sealing. If cleaning does not help, the seal needs replacing. A new seal must be fitted straight, and the door adjusted so it closes evenly, or the new seal will not fix the problem.
Fridges and freezers we work on.






Mika fridge in Thika not right?
Call or WhatsApp with what the fridge is doing and a photo of the model sticker. We tell you when a technician can come.